✔️Open optical sensors.
✔️Powered directly from the drone.
✔️Convenient and reliable load locking mechanism.

This device is a gimbal that allows you to securely attach a payload to the drone and release it when needed. The release is initiated by turning on the quadcopter's bottom light. The device is powered by the drone's battery via a Type-C connector.

Installation

The device should be positioned and secured with Velcro. When installed, it should fit snugly against the drone and be securely fastened. Connect the Type-C plug to the rear port of the drone.

Application

When the drone is turned on, the red indicator light on the device should light. The next step is to load the ammunition. To do this, adjust the length of the strap. Thread it through the hole and snap the lock. Next, install the ammunition itself and tighten it with Velcro. The tightening force should be sufficient to prevent the load from slipping. However, dragging it is also not recommended, as this can lead to problems opening.

The tightening force should be sufficient to prevent it from moving or slipping. Next, be sure to check the security of the locking mechanism by pulling and attempting to detach it. The latch should be inserted as far as it will go. The opening lever should be fully raised. Once you've verified that the munition is securely secured, the device is powered on, and loaded, you can take off by placing the drone on a flat surface and making a recess under the protruding part, or by hand-flying.

Be sure to check the backlight mode.